Yamaha XS750

From Yamaha Wiki
Jump to navigation Jump to search
XS750
Yamaha XS 750.jpg
ManufacturerYamaha Motor Company
Also calledtriple
Parent companyYamaha
SuccessorXS850
Class750cc
Engine4 stroke 3 cylinder air cooled DOHC
Transmission5 speed
SuspensionFront: Telescopic fork
Rear: Swing arm
BrakesFront: dual disc
Rear: disc
TiresFront: 3.25H-19-4PR/1.8 Kg/cm (26 psi)
Rear: 4.00H-18-4PR/2.0 Kg/cm (28 psi)
Rake, Trail27 deg / 114 mm (4.49 in)
Wheelbase1,470 mm (57.9 in)
Fuel capacity17 liters (4.5 US gal)

The Yamaha XS 750 and Yamaha XS 850 was a line of motorcycles produced by the Yamaha Motor Corporation from 1976 to 1981 for the worldwide motorcycle market. The last model year of manufacturing was 1981. Released in Japan in 1976 as the GX750 sporting wire wheels (as opposed to cast alloy in all other models) the XS750 became the name for the export model.

These bikes are usually referred to as "Triples" because they have 3 cylinders. The first 4 model years the bike displaced 750cc. This was increased to 850cc for the final 2 model years. There were various changes made to the model over the years.

1976 XS750 “C”

Very few of these bikes seem to have been made and even fewer survived. The cast wheels were in an unpainted finish and the decals were in a distinctive stripe design on the tank and side panels. This bike had a 3-1 exhaust system, and Mikuni “Mark I” carburetors. The air box assembly was different from later years. The air filter could be changed by opening the seat. This model had triple contact breaker points making timing adjustment complex. Also featured was a separate regulator and rectifier. The seat has a short tail piece this year.

1977 XS750 “D”

A number of these made it out to export markets in late 1976. This bike was pretty much the “C” with a paint job. The tank now sports the familiar piping around the contours picking out the detail. Problems with reliability led to a further release in 1977. Had the same tail piece as the "C" and early GX750.


A few of the "D" models had already the "three in two" exhaust

1977 XS750 “2D”

Released to return confidence to the model with some modifications to the “D” model. The bike now had 3 into 2 exhaust system with silencers on both sides of the bike, and improvements made to the engine to improve reliability. Fitted with electronic regulator/rectifier unit. This bike has a different seat from the "C" and "D". The tail piece is longer and doesn't fit the early seats.

1978 XS750 “E” and “SE”

The now popular “2D” was upgraded to keep up with the market. Yamaha added electronic ignition this year but retained the mechanical timing advancing unit. They also replaced the carburetors for Mikuni “Mark II” CV models. These offered easier maintenance and a “two position enricher” (Choke) as opposed to the single position on the “Mark I” model. The engine again had some improvements including cam shafts to boost the power of the engine. The rev limit was raised to 9000 rpm this year from 7500 which the electronic ignition had allowed. Later “E” models also had a viewing window for the engine oil added in place of the dipstick. This year also saw the introduction of the XS750 “SE”, Special or US custom model. With longer front forks and a teardrop shaped tank with shorter exhausts and seat it had a “Chopper” appearance in contrast to the tourer or now referred to as “Standard” XS750 “E”. The change of carburetors also meant a change of air box design and the air filter was now changed without lifting the seat.

1979 XS750 “F” and “SF”

As above but European models came with an optional 24 liter fuel tank and also a new paint scheme. The cast wheels from this year on were of the "tubeless design".

1980 XS850 “G” and “SG” “LG”

Yamaha XS 850

The 825cc replacement for the XS750 was a very similar beast. The engine received bigger barrels and pistons, a beefier crankshaft, a wider primary chain and better oil ways. The addition of an oil cooler helped keep things cool. The European 850 “G” came with the 24 liter tank as standard. Also added were frame improvements including a new swing arm mounting and alloy footrest carriers.(Also to be seen in some "F" models. In the United states, the 850 “G” had a more custom look with a seat with no tail piece like the “SG” and different side panels. The exhausts on the European models have an offset in them to improve ground clearance at the rear. The “LG” was the midnight special, sporting black and gold designs on the engine and other parts. The European models had a wider seat and tail piece than the 750’s, but looked much more like them than the American 850 “G”.

1981 XS850 “H” and “SH” “LH”

As previous year. Also the last production year although models continued to sell for a few years after this. One final change, the ignition system was updated to electronic advanced timing and the mechanical advance assembly was removed.

See also

  • Yamaha XS Eleven - the 750's and 850's bigger brother
  • Yamaha XS650 - A 650cc Twin cylinder version

External links